# Folding Tortillas for Burritos

Learn how to fold tortillas for burritos with the envelope fold: warming the flour tortilla, centering the filling, tucking the ends and rolling a tight burrito.

Folding tortillas for burritos means wrapping a warmed flour tortilla around the filling with an envelope fold. You center the filling, fold the two sides over it, tuck the near end up and roll the burrito away from you. A tight, even roll keeps the filling inside and gives the burrito a shape that holds together. 

- Warm the flour tortilla first so it bends without cracking.
- Leave a clear border of tortilla around the filling on every side.
- Fold the two sides in before you roll, so the ends are tucked.
- Roll firmly but not so tight that the filling bursts out.
 

## Warming the flour tortilla 

A flour tortilla burrito starts with a tortilla that bends without tearing. A cold tortilla cracks at the fold, and a crack lets the filling escape during rolling. 

Warm the tortilla on a dry skillet over moderate heat, turning it once, until it feels soft and pliable. A short pass in a hot pan is enough, and you can also warm tortillas in a covered stack so they stay soft. 

Keep the warmed tortillas under a clean towel while you set out the filling. A tortilla that cools down becomes stiff again and is harder to roll into a neat burrito. 

## Setting up the rolling surface 

A flat, clean surface makes the burrito fold easier to control. A cutting board or a plain countertop gives the tortilla support while you roll. 

Place the tortilla flat with its round edge facing you. A tortilla that is slightly oval should sit with the longer side toward you, so the roll has more room to close. 

Keep your hands and the surface dry. A wet surface makes the tortilla stick and slide, which spoils the shape of the roll. 

## Centering the filling 

The filling goes in a line across the middle of the tortilla, not spread to the edges. A centered line of filling leaves room for the sides and ends to fold over. 

Leave a border of bare tortilla on all four sides. The border is what closes the burrito, and a filling that reaches the edge leaks out as you roll. 

Pile the filling no higher than your hand can comfortably close around. A thick mound is hard to wrap, and a flatter line of filling rolls into a tighter burrito. 

## Folding the sides into an envelope 

The envelope fold begins with the two sides of the tortilla. Fold the left side over the filling, then fold the right side over it so the two flaps overlap. 

Press the side flaps gently against the filling. The flaps form the closed ends of the burrito, and they should sit flat rather than bunch up. 

The envelope fold keeps the filling from spilling out of the sides. A burrito folded this way holds a full scoop of beans, rice or meat without opening at the edges. 

## Tucking the ends 

Tucking the ends means folding the near edge of the tortilla up over the filling. Lift the edge closest to you and press it down against the filling line. 

Tuck the edge snugly so no gap remains between the tortilla and the filling. A loose tuck leaves a pocket of air that opens when you bite into the burrito. 

The near end is tucked before any rolling starts. This tucked edge becomes the outer flap that seals the finished burrito. 

## Rolling the burrito 

Rolling a burrito means lifting the tucked edge and rolling the tortilla away from you. Keep both hands on the roll and move them outward as the burrito grows. 

Roll with gentle, even pressure. Too little pressure makes a loose burrito that falls apart, and too much pressure squeezes the filling out of the open ends. 

Finish with the seam side down on the board. A burrito resting on its seam stays closed, and the shape holds until you serve it. 

## Fixing a torn or leaking burrito 

A small tear in the tortilla can be covered by rolling the burrito so the tear sits inside the wrap. Continue the roll and press the seam closed over the damaged spot. 

A burrito that leaks at the ends usually holds too much filling. Unroll it, remove some filling and roll it again with a wider border of bare tortilla. 

A tortilla that cracks during folding was too cold or too dry. Warm a fresh tortilla and start again, since a cracked wrap does not seal. 

## Serving and holding folded burritos 

Serve a folded burrito seam side down on a plate so it keeps its shape. Cut it in half only after the roll is complete, and cut across the middle rather than lengthwise. 

To hold several burritos, wrap each one in foil or paper and set them seam side down in a warm dish. The wrap keeps the tortilla soft and stops the burrito from unrolling. 

A burrito for later should cool before it is wrapped and stored. Steam trapped inside a warm wrap softens the tortilla and turns the filling soggy. 

## Questions About Folding Burrito Tortillas 

### How do you fold tortillas for burritos? 

Fold tortillas for burritos with the envelope fold: center the filling, fold both sides over it, tuck the near edge up and roll away from you. Warm the flour tortilla first so it bends without cracking. Finish with the seam side down. 

### How do you fold tortillas into burritos without tearing them? 

Warm the tortilla until it feels soft, keep a border of bare tortilla around the filling and roll with gentle pressure. A cold or dry tortilla cracks at the fold. If a small tear appears, roll so the tear sits inside the wrap. 

### What is an envelope fold on a burrito? 

An envelope fold means folding the two sides of the tortilla over the filling before you roll. The side flaps close the ends, and the near edge is tucked up next. The finished burrito looks like a sealed envelope around the filling. 

### Should the ends of a burrito be tucked before rolling? 

Yes, the ends are tucked before the roll begins. Lift the near edge of the tortilla and press it against the filling line. This tucked edge becomes the outer flap that seals the burrito when you finish rolling. 

### How much filling fits in a folded burrito? 

A folded burrito holds a line of filling no higher than your hand can close around. Leave a clear border of tortilla on all four sides so the sides and ends can fold. Extra filling makes the roll leak at the ends. 

### Why does a burrito fall apart after folding? 

A burrito falls apart when the roll is loose or the side flaps are not pressed flat. Roll with even pressure and finish seam side down. A tortilla that was not warmed also cracks and fails to seal.
