# Building a Raised Garden Bed from Concrete or Cinder Blocks

A plain guide to building a raised garden bed from concrete or cinder blocks: how to stack them, how high to go, the layout, and filling the cavities.

Building a raised garden bed from concrete or cinder blocks means stacking the hollow blocks into a dry wall that holds soil without mortar. You set the first course level on bare ground, stagger each course above it, and fill the open cavities with soil or gravel. The result is a sturdy block raised bed you can take apart and move later, and this page covers the layout, the height, and the filling. 

## Setting out the block bed layout 

A block bed layout starts with a string line and a spade, because the first course decides the shape of everything above it. You clear the grass, level the strip where the blocks will sit, and press the first course down onto firm bare soil. A dry stack shifts over time, so keep the corners square and check the level as you go. Mark the outside line of the wall so each block lands in the same place on every course. 

## Stacking blocks into a dry wall 

Stacking blocks for a concrete block raised bed follows masonry practice, with each course offset by half a block over the joint below. A running bond like this ties the wall together and stops a single vertical joint from running up the full height. Dry stacking means no mortar, so the wall relies on weight and a level base, and you lift each block into place rather than sliding it. Wear gloves, since block edges are rough and a dropped block can injure a foot. 

## Height and filling the block cavities 

Block raised bed height depends on what you plan to grow and how far you want to bend, so decide the reach before you stack the second course. Two courses of standard blocks give a workable bed for shallow-rooted plants, and a third course suits deeper roots but needs a wider base. Filling block cavities with soil turns the hollow cores into planting pockets for herbs or flowers along the top. Fill the wall cores with soil or gravel as you build, so the blocks settle evenly before the next course. 

## Questions about block raised beds 

### How do I build a raised garden bed with cinder blocks? 

You build a raised garden bed with cinder blocks by levelling bare ground, laying a first course of blocks, and stacking offset courses above it. Fill the block cavities with soil or gravel as you go, then line the inside and fill the bed with soil. Cinder blocks are light and easy to lift, but they are brittle and chip at the edges. A dry stack without mortar lets you adjust the bed or take it down later. 

### How do I build a raised garden bed with concrete blocks? 

Building a raised bed with concrete blocks uses the same dry stack method, with heavier blocks set on a firm, level base. Concrete blocks hold their shape well in a garden wall and are sold in standard hollow sizes that stack cleanly. Set the first course on compacted bare soil and check the level along the full length. The extra weight of concrete blocks means a level base matters more than speed. 

### How tall should a block raised bed be? 

Block raised bed height depends on the plants and on how far you want to reach, so there is no single figure. Two courses of standard blocks make a bed for shallow roots, while deeper-rooted crops need more soil depth. A bed built high enough to sit on also needs a wider base and a firm footing. Check the depth each crop needs before you decide the number of courses. 

### Should I fill the holes in the blocks with soil? 

Yes, filling the block cavities with soil is worthwhile because the hollow cores become planting pockets along the top of the wall. Herbs, small flowers and shallow-rooted plants grow well in these pockets and soften the look of the block wall. Fill the cores as you stack each course, so the wall settles evenly under the weight. Leave the pockets a little below the top edge so water does not run straight off.
